MisterCorn
Fuji
- Joined
- 8 Jan 2011
- Messages
- 9,411
I am rebuilding a scrap engine to be used to check for fitment. The engine will never be run, but I want to put all of the parts back in so that it could be used as an exchange block. Unfortunately, when I stripped it I threw away the parts which would be replaced. So I need....
The three chains which go on the IMS
The tensioner pads to go with them
3 piston circlips
Obviously I don't care about the state of these, so long as they are complete. Has anybody got any chucked in a corner they don't need?
Thanks.
MC
The three chains which go on the IMS
The tensioner pads to go with them
3 piston circlips
Obviously I don't care about the state of these, so long as they are complete. Has anybody got any chucked in a corner they don't need?
Thanks.
MC