Swine11 Reboot - fitment issues

SP7777 · 19 Jun 2024

I've fitted a a Swine11 ReBoot to my 993 C2 without issue, but I'm now having a lot of trouble getting into 2nd gear and I can’t get into 6 at all, due to the swine boot. The install looks fine. Going for 3rd and 5th still hits the boot at the top, so I don’t think I've re-fitted the console in the wrong place.

Has anyone come across this problem? The shift in my car is completely standard.

Thanks!

gunner · 20 Jun 2024

Slightly different scenario but I did have to get the dremel out when I did the same mod to my tiptronic.

Croydon · 21 Jun 2024

I had to shim away some of the plastic as had contact its hidden by the rubber gaiter so not noticeable.

Ian

PeterHoward · 21 Jun 2024

For something that is so simple yet soooo expensive you would hope it would fit without any drama!

Croydon · 21 Jun 2024

Yep its a design fault as you can see I had 2nd and more so 6th cut away. it worked and you can t see it.

Have PMd

Ian

moo75x · 25 Jun 2024

@gunner can you post a pic of how you did this on tip g/box please?

GilesHanna · 25 Jun 2024

moo75x said:
@gunner can you post a pic of how you did this on tip g/box please?

Ditto.

Note I had this issue when fitted to my previous 964. I’ll stick my neck out here . I dont think it’s a design defect . I think this is due to bolting up the centre console.
Ie I loosened the fixings pulled the console back - probably 3-5mm and resecured - no issues.
With respect it might be how people are fitting - not the unit.

gunner · 26 Jun 2024

The same way you would do it on a manual I imagine?

I can't remember exactly where the contact was, but a little bit of remodelling and it fitted OK. As mentioned above, the gaitor covered the area anyway.