Hi,
Been digging around the car a bit (only had it a short while)
I removed the trim inside the front hood to check the drain holes, they seemed fine, but what I did notice, was the tops of the suspension legs which are covered by black plastic discs, are slightly different heights??
I accidentally knocked the near side one and it popped off, I then looked at the Off side one and it was clipped in much tighter. When I went to replace the near side one again, it wouldn't actually fit due to a few mil of the suspension leg sitting above the body work, and therefore preventing the plastic disc from sitting flush with the top of the hole it lives in.
This strikes me as a bit odd? Surely both legs should sit at the same height?
Attached are a couple of photos.
Cheers in advance,
Stoddy. :dont know:
Been digging around the car a bit (only had it a short while)
I removed the trim inside the front hood to check the drain holes, they seemed fine, but what I did notice, was the tops of the suspension legs which are covered by black plastic discs, are slightly different heights??
I accidentally knocked the near side one and it popped off, I then looked at the Off side one and it was clipped in much tighter. When I went to replace the near side one again, it wouldn't actually fit due to a few mil of the suspension leg sitting above the body work, and therefore preventing the plastic disc from sitting flush with the top of the hole it lives in.
This strikes me as a bit odd? Surely both legs should sit at the same height?
Attached are a couple of photos.
Cheers in advance,
Stoddy. :dont know: