Welcome to the @Porsche911UK website. Register a free account today to become a member! Sign up is quick and easy, then you can view, participate in topics and posts across the site that covers all things Porsche.
Already registered and looking to recovery your account, select 'login in' and then the 'forget your password' option.
DJP997 said:I replaced with Meyle on my 996t - regretted it quickly and replaced with original parts.
Not worth cutting corners, just my opinion (but based on experience)
jerzybondov said:DJP997 said:I replaced with Meyle on my 996t - regretted it quickly and replaced with original parts.
Not worth cutting corners, just my opinion (but based on experience)
Fitted on the front / back, or both?
lenny said:Any other opinions or good manufacturers other than Meyle and OEM?
:thumb:
nordicmatter said:The meyle arms are not Porsche arms and the quality is some what different from the original TRW Porsche OE supplier. There is light at the end of the tunnel regarding theses considerably cheaper arms.
The ball joint is good quality and the inner bush is ok with a shore hardness of around 74-77. I measured a genuine porsche bush at a consistent 80 shore. The middle bush is very different and I purchased 5 meyle arms new and the stiffness is two thirds that of an original item at around 55- 66 shore and the Porsche is again a very consistent 80. There is a very cheap fix which I will post over the next week or so. This improves these arms better than the original ones and the drive is vastly improved. I am sure these arms are great for a boxster but on the turbo 996 and the very early 997S (same rear arms as 996) they cause the dreaded weave under hard acceration. According to google research Porsche had a fix of turning the centre bush 90 degrees to basically change the load points on the bush to act like a solid bush as per later cars. I have not confirmed this with a dealer but google 997 wiggle. These arms are also 6mm shorter than original but this is of no concearn as this can be dialled out when tracked. The other non branded eBay arms were terrible and during basic testing the centre bush split at less than 130kg. I had some old genuine arms that took 400 kg + at 12 years old. Hope this helps as it is a little project I have been working on over the past few months.
Mark
MisterCorn said:Yes, easy if the bolts aren't seized. More of a pain if they are.
MC