Evening All,
I dropped my car off at the local specialist today to have an Alcantara lower dash fitted. Glovebox side went on fine but the drivers side was difficult.
They could not get the instrument surround out - which is required to access the final bolt holding in the lower dash.
locating screws were removed but the bezel would not budge - they did not want to pull too hard in case they broke it (I've since confirmed that a new one can be bought for £60 - not too bad)
has anyone else done this? any tips? I've not found anything online unfortunately.
Thanks
Mark
I dropped my car off at the local specialist today to have an Alcantara lower dash fitted. Glovebox side went on fine but the drivers side was difficult.
They could not get the instrument surround out - which is required to access the final bolt holding in the lower dash.
locating screws were removed but the bezel would not budge - they did not want to pull too hard in case they broke it (I've since confirmed that a new one can be bought for £60 - not too bad)
has anyone else done this? any tips? I've not found anything online unfortunately.
Thanks
Mark